Isotropix Forums

Autosave in the background

Autosave in the background

Unread postby devinj898 » Wed Apr 25, 2018 7:14 am

Is there any way to just do the autosaves in the background? Every time it autosaves, everything is greyed out and I'm usually right in the middle of doing something. It's particularly annoying when I move/scale/rotate and then it autosaves and I pretty much have to just undo and start the transformation over again. Of course I can just set the autosave to longer time increments, but I would prefer to have the more frequent autosaves, just without the major interruptions.
devinj898
 
Posts: 23
Joined: Mon May 05, 2014 7:36 am

Re: Autosave in the background

Unread postby isoyann » Mon Apr 30, 2018 1:57 pm

Hi,

Auto save should only take a fraction of a second.. if not, this mean your project have lot of embedded data (maybe particles containers?) The best for this kind of data is to reference them (in another clarisse project), so when you save, you don't have to rewrite all of this..
And doing this in the background is not technically feasible unfortunately..

Thanks,

Yann
User avatar
isoyann
 
Posts: 640
Joined: Mon Jan 28, 2013 11:11 am


Return to Feature Requests Archives
cron