Isotropix Forums

Hi.
I have a question.
export an asset and textures from megascan. I apply them in clarisse and everything works perfectly, except for the displace, I place it at 1m and it doesn't show any kind of detail, I upload it to 11m and it starts to show detail but leaves everything round.
There will be some setting that I am missing apart from applying the displace in the linker material, and to the geometry increase the subdivisions.
Thank you

Hi,

this pillow effect come from the front offset value in your displacement node.
Megascan and Z-brush export the value from 0 to 1 and you have to offset it by setting Front Offset attribute to -0.5 to not only push all the time in one direction.

Without Offset


With Offset


Cheers