Isotropix Forums

Megascan displace problems

General Discussion about Isotropix and CG related topics

Megascan displace problems

Unread postby crissvfx » Mon Feb 08, 2021 5:30 pm

Hi.
I have a question.
export an asset and textures from megascan. I apply them in clarisse and everything works perfectly, except for the displace, I place it at 1m and it doesn't show any kind of detail, I upload it to 11m and it starts to show detail but leaves everything round.
There will be some setting that I am missing apart from applying the displace in the linker material, and to the geometry increase the subdivisions.
Thank you
Attachments
disP_11m.JPG
disP_1m.JPG
crissvfx
 
Posts: 4
Joined: Fri May 01, 2020 2:04 am

Re: Megascan displace problems

Unread postby aaute » Tue Feb 09, 2021 9:45 am

Hi,

this pillow effect come from the front offset value in your displacement node.
Megascan and Z-brush export the value from 0 to 1 and you have to offset it by setting Front Offset attribute to -0.5 to not only push all the time in one direction.

Without Offset
Image

With Offset
Image

Cheers
Aymeric
Isotropix
Technical Artist - Clarisse Specialist
User avatar
aaute
 
Posts: 45
Joined: Mon Nov 02, 2020 11:59 am


Return to General Discussion